Wiring An In Line Switch. First, tighten the bare copper or green wire to the green. Bend the ends of the wire into a half moon shape to go around the screws.
Understanding House Wiring Understanding Home Electrical Wiring from wiring06.blogspot.com
In the photo above, the green arrow points to the line hot wire connected. After all of the wires are secure, the switches can be secured back into the. If you run into short wires, there’s an easy fix.
Web Leave The Wires Long Enough To Protrude At Least 3 In.
Once done, free the terminal wires, using pliers if. Web this is installed in the wire hole labelled with the ground symbol (shown below). Web it’s a case of take your time to make a neat wiring job.
Make Sure That The Wires Are Snug In Their Slots Without Being Pinched.
Bend the ends of the wire into a half moon shape to go around the screws. After all of the wires are secure, the switches can be secured back into the. Install the switch covers, turn on the power, and then check the switches.
If You Run Into Short Wires, There’s An Easy Fix.
In the photo above, the green arrow points to the line hot wire connected. Web place the other side of the inline switch on top of the one with the wires. Please do not over tighten the live terminal as this may break the rivet holding it in place.
Loosen The Screws Holding The Terminal Wires In Place.
This is the wire that provides the 120 volts of power to your switch from the power. Disconnect the terminal and ground wires. Web connecting the new switch.
First, Tighten The Bare Copper Or Green Wire To The Green.
